It does pay off though by ensuring the footprint will match the part. This can get very frustrating, particularly if the datasheet mechanical dimensioning requires you to go through a lot of mathematical gymnastics to arrive at the correct dimension. You tend to also shift pads around manually I like to double-click on the pin and explicitly set the x/y location based on the datasheet. my power and ground pins are grouped together and (when possible) offset by the amount of space that a capacitor symbol takes, that my enables or other inputs are on one side of the component and outputs on the other, etc. The schematic is the logical representation of the circuit if it makes sense to have the logical and physical pins in the same location that's great, but I tend to organize my part's schematic object so that the pins yield to easy schematic 'flow'.

I also am not a fan of the schematic pin order being the package pin order. Having the silkscreen butting right up to the bare copper can also cause problems with placement and reflow. Some very fine pitch components want this (and others do not) but for the types of components in your video I don't see any clear advantage to this. I don't like soldermask defined pads, which is essentially what you've done by setting the expansion to zero. I'm a little concerned about how you specify your soldermask expansion to zero I tend to leave it at defaults which tend to give good results. You may also want to make sure the silkscreen widths are compatible with your board house I tend to make all my silkscreen line widths 4-5mil which works great with most PCB houses, including Hackvana, my favourite board house. The Wizard is the absolute fastest, but using the origin marker with copy/paste and using paste array go a long way in making footprint creation easier. You can also save a LOT of hassle by using the 'paste array' when designing the footprints for ICs. This makes it VERY easy to offset pins or perform precise positioning relative to some point.

Then when you use ^V the paste center will be that point you selected when copying. You get a crosshair which is asking you for the 'reference point' for the copy, and you can easily snap to the exact center of a pad or end of a line or, as you did, any arbitrary point. in layout, you select the parts, the ^C to copy. Good video, thank you for taking the time to record and upload it! Couple notes though.

Altium designer video tutorials